TechniSat Car Radio User Manual download pdf (Page 12)

Calling up the stations memorized as above:

- Activate the memory positions on which the programmes of the

selected frequency range have been stored by means of a short push

on the button.

- The six programmes stored can be called up by pushing the

buttons

Automatic station search:

The TechniSat WERRA 1 is equipped with an automatic station search system

which stops on the first station received after starting.The reception range which

has just been selected is searched through.

The searching sensitivity can be switched by the button.

Adjusting the searching sensitivity:

- By a short push on the button you can switch the searching

sensitivity between “local“ (display on device: “LOC“) and “normal“.

When set to “local“ the automatic station search stops only at stations which can

strongly be received. If no station can be found the function will automatically

switch to normal searching sensitivity.

LOC

AST

3.2.2 Station search/station memory

The TechniSat WERRA 1 offers four different possibilities to search for the radio

station: manual station search,automatic station search,AST function and

search for the type of programme.

The stations which have been found can then be stored separately for each

band selected under 3.2.1.For each band a maximum of six stations can be

stored.

AST function:

With the AST function you have the possibility to find and to store the six

strongest stations of the FM or the MW band by means of one simple push on

the button.This function can be called up as follows:

- Select the FM or the MW band as described under 3.2.1.

- Push and hold the button for approx.2 seconds until a signal tone

can be heard.Now the AST function starts to work.During the station

search the message “STORE“ is displayed.

After a few seconds the station search and memory is finished.The stations

which have been found are stored under “AST“ separately for the selected

frequency range.This has no influence on the stations which are stored under

“F1“,“F2“ or “MW“.After completion you can quit the AST range by pushing the

button.

BAND

AST

3 Detailed instructions 3 Detailed instructions

Quit the AST range

Push AST for

approx.2 sec.

until signal can

be heard; “STORE“

is displayed

Select the desired programme

Shortly push AST

Shortly push LOC

REG

AST AF TP

PTY

REG

AST AF TP

PTY

Bed.Anl. Werra1 englisch 09.04.1998 11:53 Uhr Seite 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

TechniSat Car Radio User Manual Page 12

Comments to this Manuals