TechniSat Viotenne 55 Twin Installation Manual download pdf (Page 5)

3. Safety instructions

Take care to ensure that the applicable European standards and VDE rules for guaranteeing

electrical safety (e.g. VDE 0855, Part 1) are observed when installing.

Ask your specialist supplier about this if necessary.

4. Fitting the F plug

Warning!

Only fit the F plug when the receiver is switched off!

When fitting the F plug, ensure that it is correctly fitted so as to avoid any operational faults

or even the destruction of the Sat-receiver.

> Remove 6mm of insulation from the end of the wiring using a sharp knife as far as

the internal lead. When doing this, ensure that the internal lead is not damaged.

> Remove the remaining wiring from the surrounding flex.

Now remove 10mm of the outer plastic sleeve until the sheathing flex is opened up

without being damaged.

> Ensure that none of the wiring from the surrounding flex is touching the internal lead.

> Now turn the F plug carefully on the cable until the inner lead end is flush with the

front edge of the F plug

Finally check once again that none of the wire from the surrounding flex is touching

the internal cable lead. The F plug is now correctly installed.

Observe the appropriate assembly method by using Crimp F plugs and follow the

manufacturer's instructions.

No exposed wires!

Wire mesh

Silver foil

Screw-in F plug

1 2 3 4 5 6 7 8 9 10 ... 125 126

No comments

TechniSat Viotenne 55 Twin Installation Manual Page 5