Technisat TechniStar K2 ISIO User Manual download pdf (Page 20)

8 Operating the unit

8.1 Switching on

> Switch the digital receiver on by pressing the On/Stand-by button either on the

receiver panel or on the remote control.

> Change to an unblocked channel

If the user-dependent parental control (TechniFamily) is activated, the user selection

will appear.

8.2 Switching off

> Press the On/Stand-by key either on the receiver panel or on the remote control to

switch the receiver off again.

> The receiver is now in standby mode, and the time is displayed on the receiver

panel. If the time is not shown, the receiver still needs to acquire it. To do this, switch

the receiver on and set it to receive a local TV channel for approx. 30 seconds to

automatically acquire the time.

8.3 Channel selection

8.3.1 Using the channel up/down keys

> Use the up/down arrow buttons on the receiver to select a channel, or use the

Channel +/- buttons on the remote control to scroll up or down the channel settings.

8.3.2 Using the numeric pad keys

> Use the numeric keypad keys to enter the number of the channel you want.

For example:

1 for channel slot 1

1, then 4 for channel slot 14

2, then 3, then 4 for channel slot 234

1, then 5, then 6, then 7 for channel slot 1567

When entering channel numbers with multiple digits, you have approx. three seconds after

pressing a key to complete the entry.

If you wish to enter a number consisting of only one, two or three digits, you can speed up

the entry procedure by keeping the key depressed a little longer on the last digit.

8.3.3 Using the Navigator (channel list)

> Press the OK button.

The channel list navigator is now displayed. In TV mode only TV channels are shown,

and in radio mode only radio channels are shown.

The channel currently selected is highlighted.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

No comments

Technisat TechniStar K2 ISIO User Manual Page 20