Technisat TechniStar K2 ISIO User Manual download pdf (Page 3)

2 Please read this first

Before connecting and using the device, first check that everything has been supplied and

familiarise yourself with the safety instructions.

You should have received:

1 Digital receiver, 1 Remote control, 2 Batteries (1.5V micro-cell), 1 HDMI cable,

1 mains cable.

2.1 Safety instructions

For your own protection you should read the safety precautions carefully before using your

new receiver.

The manufacturer accepts no liability for damage caused by inappropriate handling, or by

non-compliance with the safety precautions.

Function-related discharge current may occur with electrical equipment. This is

acceptable and poses no risk, even if it is experienced as a slight tingling.

To prevent such discharge current, mains operated devices (receivers, TVs etc) must

always be installed or connected with the power switched off, i.e. all devices must be

disconnected from the mains.

- Only operate the receiver in a temperate climate.

- To ensure adequate ventilation, place the receiver on a flat, horizontal surface and

do not place any objects on top of it. There are ventilation slots here to allow heat to

be dissipated from the interior of the unit.

- Do not place any burning objects, such as lit candles, on top of the receiver.

- Do not expose the receiver to water droplets or water spray, and do not place

any objects filled with liquid, such as vases, on top of it. If water gets into the unit,

immediately remove the mains plug and inform the service department.

- Do not operate any sources of heat near the receiver which may also heat it up.

- Do not obstruct the ventilation slots.

1 illustration

cable-

out

DC-in

digital audio

out

analogue audio

out

SCART-socket

analogue audio

out

Ethernet-

interface

cable-in

HDMI-

out

IR-

connection

USB-

interfaces

ON/Standby

arrow button up/down

TV/Radio

LED-display

CI-slot

card reader:

> Insert the CONAX-Smartcard

(golden Chip face down and alingned

in insertion direction) till the as far as

it willl go.

Inserting the CI / CI+ -module:

> Please refer to the manual of the manufacturer of the CI / CI+ -module

and the card.

> Insert the appropriate smartcard in the corresponding

CI-module.

> Insert the CI-module into the CI-slot carefully.

KA_TechniStar K2 ISIO_V1_50_2233635000200.qxp 05.10.2012 09:46 Seite 2

1 2 3 4 5 6 7 8 ... 35 36

Comments to this Manuals

No comments

Technisat TechniStar K2 ISIO User Manual Page 3

Comments to this Manuals